Syslog Commands; Logging On - HP Bc1500 - BladeSystem - Blade PC Reference Manual

logging on

The logging on Global Configuration mode command controls error message logging. This
command sends debug or error messages to a logging process, which logs messages to
designated locations asynchronously to the process that generated the messages. To disable the
logging process, use the no form of this command.
Syntax
logging on
no logging on
Parameters
There are no parameters for this command.
Default Setting
Logging is enabled.
Command Mode
Global Configuration mode
Command Usage
The logging process controls the distribution of logging messages at various destinations, such as
the logging buffer, logging file or syslog server. Logging on and off at these destinations can be
individually configured using the logging buffered, logging file, and logging Global
Configuration mode commands. However, if the logging on command is disabled, no messages
are sent to these destinations. Only the console receives messages.
Example
The following command enables logging error messages.
Console(config)# logging on
HP PC Blade Switch CLI Reference Guide

Syslog Commands

www.hp.com
24
24-1