Dot1X Port-Control - HP Bc1500 - BladeSystem - Blade PC Reference Manual

dot1x port-control

The dot1x port-control Interface Configuration mode command enables manually controlling
the authorization state of the port. To return to the default configuration, use the
command.
Syntax
dot1x port-control {auto | force-authorized | force-unauthorized}
no dot1x port-control
Parameters
■
auto — Enables 802.1x authentication on the interface and causes the port to transition to
the authorized or unauthorized state based on the 802.1x authentication exchange between
the port and the client.
■
force-authorized — Disables 802.1x authentication on the interface and causes the port to
transition to the authorized state without any authentication exchange required. The port
resends and receives normal traffic without 802.1x-based authentication of the client.
■
force-unauthorized — Denies all access through this interface by forcing the port to
transition to the unauthorized state and ignoring all attempts by the client to authenticate.
The device cannot provide authentication services to the client through the interface.
Default Configuration
Port is in the force-authorized state
Command Mode
Interface Configuration (Ethernet)
Command Usage
It is recommended to disable spanning tree or to enable spanning-tree PortFast mode on 802.1x
edge ports (ports in auto state that are connected to end stations), in order to get immediately to
the forwarding state after successful authentication.
Example
The following command enables 802.1x authentication on Ethernet port 1/e16.
Console(config)# interface ethernet 1/e16
Console(config-if)# dot1x port-control auto
HP PC Blade Switch CLI Reference Guide www.hp.com
802.1x Commands
no
form of this
2-3