Spanning-Tree Disable - HP Bc1500 - BladeSystem - Blade PC Reference Manual
Blade switch
Hide thumbs
Also See for Bc1500 - BladeSystem - Blade PC:
- User manual (216 pages) ,
- Setup and installation manual (149 pages) ,
- Supplementary manual (45 pages)
Table of Contents
Advertisement
spanning-tree disable
The spanning-tree disable Interface Configuration mode command disables spanning tree on a
specific port. To enable spanning tree on a port, use the no form of this command.
Syntax
spanning-tree disable
no spanning-tree disable
Parameters
There are no parameters for this command.
Default Setting
Spanning tree is enabled on all ports.
Command Modes
Interface Configuration (Ethernet, port-channel) mode
Command Usage
There are no user guidelines for this command.
Example
The following command disables spanning-tree on Ethernet port 1/e5.
Console(config)# interface ethernet 1/e5
Console(config-if)# spanning-tree disable
HP PC Blade Switch CLI Reference Guide
www.hp.com
Spanning-Tree Commands
22-7
Advertisement
Table of Contents
