Dot1X Timeout Supp-Timeout - HP Bc1500 - BladeSystem - Blade PC Reference Manual

802.1x Commands

dot1x timeout supp-timeout

The dot1x timeout supp-timeout Interface Configuration mode command sets the time for the
retransmission of an Extensible Authentication Protocol (EAP)-request frame to the client. To
return to the default configuration, use the no form of this command.
Syntax
dot1x timeout supp-timeout seconds
no dot1x timeout supp-timeout
Parameters
■
seconds — Time in seconds that the device waits for a response to an EAP-request frame
from the client before resending the request. (Range: 1-65535 seconds)
Default Configuration
Default timeout period is 30 seconds.
Command Mode
Interface configuration (Ethernet) mode
Command Usage
The default value of this command should be changed only to adjust for unusual circumstances,
such as unreliable links or specific behavioral problems with certain clients and authentication
servers.
Example
The following command sets the timeout period before retransmitting an EAP-request frame to
the client to 3600 seconds.
Console(config-if)# dot1x timeout supp-timeout 3600
2-10 www.hp.com HP PC Blade Switch CLI Reference Guide