Spanning-Tree Link-Type - HP Bc1500 - BladeSystem - Blade PC Reference Manual

spanning-tree link-type

The spanning-tree link-type Interface Configuration mode command overrides the default
link-type setting determined by the duplex mode of the port and enables Rapid Spanning Tree
Protocol (RSTP) transitions to the forwarding state. To return to the default configuration, use the
no form of this command.
Syntax
spanning-tree link-type {point-to-point | shared}
no spanning-tree link-type
Parameters
■
point-to-point —Indicates that the port link type is point-to-point.
■
shared — Indicates that the port link type is shared.
Default Setting
The device derives the port link type from the duplex mode. A full-duplex port is considered a
point-to-point link and a half-duplex port is considered a shared link.
Command Modes
Interface Configuration (Ethernet, port-channel) mode
Command Usage
There are no user guidelines for this command.
Example
The following command enables shared spanning-tree on Ethernet port 1/e5
Console(config)# interface ethernet 1/e15
Console(config-if)# spanning-tree link-type shared
HP PC Blade Switch CLI Reference Guide www.hp.com
Spanning-Tree Commands
.
22-11