Ip Igmp Snooping Mrouter-Time-Out - HP Bc1500 - BladeSystem - Blade PC Reference Manual
Blade switch
Hide thumbs
Also See for Bc1500 - BladeSystem - Blade PC:
- User manual (216 pages) ,
- Setup and installation manual (149 pages) ,
- Supplementary manual (45 pages)
Table of Contents
Advertisement
IGMP Snooping Commands
ip igmp snooping mrouter-time-out
The ip igmp snooping mrouter-time-out Interface Configuration (VLAN) mode command
configures the mrouter-time-out. The ip igmp snooping mrouter-time-out Interface
Configuration (VLAN) mode command is used for setting the aging-out time after multicast
device ports are automatically learned. To return to the default configuration, use the no form of
this command.
Syntax
ip igmp snooping mrouter-time-out time-out
no ip igmp snooping mrouter-time-out
Parameters
■
time-out — Multicast device timeout in seconds. (Range: 1-2147483647)
Default Setting
The default value is 300 seconds.
Command Mode
Interface Configuration (VLAN) mode
Command Usage
There are no user guidelines for this command.
Example
In the following example, the multicast device timeout is configured to 200 seconds.
Console(config)# interface vlan 2
Console(config-if)# ip igmp snooping mrouter-time-out 200
10-4
www.hp.com
HP PC Blade Switch CLI Reference Guide
Advertisement
Table of Contents
