Ethernet Configuration Commands
back-pressure
The back-pressure Interface Configuration (Ethernet, port-channel) mode command enables
back pressure on a given interface. To disable back pressure, use the no form of this command.
Syntax
back-pressure
no back-pressure
Parameters
There are no parameters for this command.
Default Setting
Back pressure is disabled.
Command Mode
Interface Configuration (Ethernet, port-channel) mode
Command Usage
There are no user guidelines for this command.
Example
In the following example, back pressure is enabled on port 1/e5.
Console(config)# interface ethernet 1/e5
Console(config-if)# back-pressure
8-10
www.hp.com
HP PC Blade Switch CLI Reference Guide