Line Commands
exec-timeout
The exec-timeout Line Configuration mode command sets the interval that the system waits
until user input is detected. To return to the default configuration, use the no form of this
command.
Syntax
exec-timeout minutes [seconds]
no exec-timeout
Parameters
■
minutes — Specifies the number of minutes. (Range: 0-65535)
■
seconds — Specifies additional time intervals in seconds. (Range: 0-59)
Default Setting
The default configuration is 10 minutes.
Command Mode
Line Configuration mode
Command Usage
To specify no timeout, enter the exec-timeout 0 command.
Example
The following command configures the interval that the system waits until user input is detected
to 20 minutes.
Console(config)# line console
Console(config-line)# exec-timeout 20
13-4
www.hp.com
HP PC Blade Switch CLI Reference Guide