Management Acl Commands; Management Access-List - HP Bc1500 - BladeSystem - Blade PC Reference Manual

management access-list

The management access-list Global Configuration mode command configures a management
access list and enters the Management Access-list Configuration command mode. To delete an
access list, use the no form of this command.
Syntax
management access-list name
no management access-list name
Parameters
■
name — Access list name. (Range: 1-32 characters)
Default Setting
This command has no default configuration.
Command Mode
Global Configuration mode
Command Usage
Use this command to configure a management access list. The command enters the Access-list
Configuration mode, where permit and deny access rules are defined using the permit
(Management) and deny (Management) commands.
If no match criteria are defined, the default is deny.
If you reenter an access list context, the new rules are entered at the end of the access list.
Use the management access-class command to select the active access list.
The active management list cannot be updated or removed.
Management ACL requires a valid management interface, which is a port, VLAN, or
port-channel with an IP address or console interface. Management ACL only restricts access to
the device for management configuration or viewing.
HP PC Blade Switch CLI Reference Guide

Management ACL Commands

www.hp.com
14
14-1