Show Ipv6 Lisp - Cisco Nexus 7000 Series Command Reference Manual

show ipv6 lisp

S e n d d o c u m e n t c o m m e n t s t o n e x u s 7 k - d o c f e e d b a c k @ c i s c o . c o m .
show ipv6 lisp
To display the only IPv6 configuration status, use the show ipv6 lisp command.
This command has no arguments or keywords
Syntax Description
None
Defaults
Any command mode
Command Modes
network-admin
Supported User Roles
network-operator
vdc-admin
vdc-operator
Command History Release
5.0(1.13)
This command does not require a license.
Usage Guidelines
This example shows how to display the LISP IPv6 configuration status:
Examples
switch# show ipv6 lisp
LISP IPv6 Configuration Information for VRF "default" (iid 0)
Ingress Tunnel Router (ITR):
Egress Tunnel Router (ETR):
Proxy-ITR Router (PTR):
Proxy-ETR Router (PETR):
Map Resolver (MR):
Map Server (MS):
Last-resort source locator:
LISP-NAT Interworking:
ITR send Map-Request:
ITR send Data-Probe:
LISP-ALT vrf:
ITR Map-Resolver:
ETR Map-Server(s):
Last Map-Register sent to MS:
ETR glean mapping:
ETR accept mapping data:
ETR map-cache TTL:
Send IP Map-Reply:
Shortest EID-prefix allowed:
Use Proxy-ETRs:
Cisco Nexus 7000 Series NX-OS LISP Command Reference
LSP-170
show ipv6 lisp
Modification
This command was introduced.
enabled
enabled
disabled
disabled
disabled
disabled
2001:db8:d01:9c::80df:9c17
disabled
enabled
disabled
not configured
172.22.156.35
172.22.156.35, 172.22.132.89
00:00:20
disabled, verify disabled
disabled, verify disabled
24 hours
enabled
/48
172.16.2.1
Cisco Nexus 7000 Series LISP Commands