Show Ipv6 Access-Lists - Cisco Nexus 7000 Series Command Reference Manual

Show Commands

show ipv6 access-lists

To display all IPv6 access-control lists (ACLs) or a specific IPv6 ACL, use the show ipv6 access-lists
command.
show ipv6 access-lists [ access-list-name ] [expanded| summary]
Syntax Description
access-list-name
expanded
summary
Command Default
None
Command Modes
Any command mode
Command History
Release
4.2(1)
4.1(2)
Usage Guidelines
The device shows all IPv6 ACLs, unless you use the access-list-name argument to specify an ACL.
If you do not specify an ACL name, the device lists ACLs alphabetically by the ACL names.
IPv6 address object groups and IP port object groups show only by name, unless you use the expanded
keyword.
The expanded keyword allows you to display the details of object groups used in an ACL rather than only
the name of the object groups. For more information about object groups, see the object-group ipv6 address
and object-group ip port commands.
The summary keyword allows you to display information about the ACL rather than the ACL configuration.
The information displayed includes the following:
(Optional) Name of an IPv6 ACL, which can be up
to 64 alphanumeric, case-sensitive characters.
(Optional) Specifies that the contents of IPv6 address
groups or port groups show rather than the names of
object groups only.
(Optional) Specifies that the command displays
information about the ACL rather than the ACL
configuration. For more information, see the "Usage
Guidelines" section.
Modification
Command output is sorted alphabetically by the ACL names.
Support was added for the fragments command.
This command was introduced.
Cisco Nexus 7000 Series Security Command Reference
show ipv6 access-lists
809