Area Nssa; Area Range - Dell Force10 S4810P Reference Manual

Usage In the Dell Force10 operating software (FTOS), cost is defined as reference bandwidth/
Information bandwidth.
Related area stub
Commands

area nssa

Specify an area as a not so stubby area (NSSA).
C-Series, E-Series, S-Series, Z-Series, S4810
Syntax area area-id nssa [default-information-originate] [no-
redistribution] [no-summary]
To delete an NSSA, use the no area area-id nssa command.
Parameters
area-id
no-redistribution
default-
information-
originate
no-summary
Defaults Not configured.
Command Modes ROUTER OSPF
Command History
Version 8.3.11.1
Version 8.3.7.0
Version 7.8.1.0
Version 7.6.1.0
Version 7.5.1.0
pre-Version
6.1.1.1

area range

Summarize routes matching an address/mask at an area border router (ABR).
C-Series, E-Series, S-Series, Z-Series, S4810
Syntax area area-id range ip-address mask [not-advertise]
1144
– creates a stub area.
Specify the OSPF area in dotted decimal format (A.B.C.D.) or enter a
number from zero (0) to 65535.
(OPTIONAL) Specify that the redistribute command should not
distribute routes into the NSSA. You should only use this command in
a NSSA area border router (ABR).
(OPTIONAL) Allows external routing information to be imported into
the NSSA by using Type 7 default.
(OPTIONAL) Specify that no summary LSAs should be sent into the
NSSA.
Introduced on the Z9000.
Introduced on the S4810.
Added support for the Multi-Process OSPF.
Introduced on the S-Series.
Introduced on the C-Series.
Introduced on the E-Series.