Table 30: Show Sscc Info Output Fields - Juniper JUNOSE 11.1.X - BROADBAND ACCESS CONFIGURATION GUIDE 6-4-2010 Configuration Manual

JUNOSe 11.1.x Broadband Access Configuration Guide
Table 30 on page 154 lists the show sscc info command output fields.
Meaning

Table 30: show sscc info Output Fields

154
Monitoring SRC Client Connection Status
Tokens Seen
Active Tokens
Token Transitions
Token Creates Sent
Token Deletes Sent
Active Addresses
Address Transitions
Create Addresses Sent
Delete Addresses Sent
Authentication Successes
Authentication Failures
Field Name
The SSC client configured
protocols
The SSC client configured
servers
Local Source
Local Source Address
The configured transport
router is
The configured retry timer
is (seconds)
The configured
update-policy-request is
The connection state is
0
0
0
0
0
0
0
0
0
0
0
Field Description
Protocols that are enabled on the virtual router for policy and QoS
management by the SRC software
IP addresses of the primary, secondary, and tertiary SAEs
Fixed source interface for the TCP/COPS connection
Fixed source address for the TCP/COPS connection
Router on which is TCP/COPS connection is established
Delay period the client waits for a response from the SAE before
submitting request again
Whether the router or the SRC client retrieves DSL line rate
parameters, whenever the values change after connection
establishment, from ANCP and transfers the details to the COPS
server with other COPS messages, enabled or disabled
Current state of the TCP/COPS connection