Power And Setup Issues - Xante AW 1200 User Manual

BD/Laser
EP Cartridge Error

Power and Setup Issues

This section provides tips for resolving problems concerning power to the printer and
the host or printer setup.
My printer has no power.
• Make sure the power cord is plugged into the printer and the power source
(see "Connecting the Power Cord" in chapter 1).
• Make sure the printer is turned on.
• Make sure the power source is grounded, working, and rated for 100 VAC
The printer has power but no start-up page prints.
• Make sure the start-up page feature is enabled by downloading the
STARTPG.ON file to the printer (see "PS Files Folder" in chapter 2
[Macintosh] or "PS_Files Folder" in chapter 3 [PC]).
• Make sure the toner cartridge is installed properly (see "Removing and
Installing the Toner Cartridge" in chapter 1).
• Make sure there is media in the selected tray and the tray is properly
installed (see "Standard Cassette" or "Multipurpose Cassette" in chapter 1).
My printer does not respond properly to my PC using a parallel connection.
• Make sure all cables are connected and seated properly (see "Connecting to
the Parallel Port" in chapter 1).
• Make sure the correct Adobe PostScript printer driver and your printer's
PPD are installed and configured properly (see chapter 3, "PC: Installing
Utilities and Drivers," for details).
• Make sure ECP is set in CMOS setup.
If printing binary data, make sure the parallel mode is set to PS TBCP.
• Make sure the printer is online and ready to print. The left status light
(LED 1) should be on and not blinking.
10% (90 to 110V); 50/60 Hz
Contact XANTÉ Technical Support. See
"Technical Support" later in this chapter.
Contact XANTÉ Technical Support. See
"Technical Support" later in this chapter.
3 Hz.
Troubleshooting – 8-5