Verify The Printer Setup; Connecting The Power Cord; Starting The Printer - Xante Accel-a-Writer 8300 Introduction Manual

8. Select the manual feed tray as the media source using the Tray
Select key or the Tray Switch menu on the printer's front
panel. The media source also can be selected using the Print
dialog box in your application.

Verify the Printer Setup

Check the printer setup by starting the printer and reviewing the
start-up page that automatically prints.

Connecting the Power Cord

The power receptacle is on the back of the printer at the lower left.
Make sure the printer's power switch is off (the O is pressed in).
1.
2. Connect the female end of the power cord to the printer.
3. Connect the male end of the power cord to a standard electrical
outlet (grounded AC outlet).
Note: You may want to use a surge protected outlet to help prevent
fluctuations in the power source from damaging your printer.

Starting the Printer

The power switch is on the front of the printer in the lower right
corner.
1. Locate the power switch.
2. Press the | on the power switch to turn on the printer. The
green Ready light flashes and Accel-a-Writer appears in the
display window.
__________________________________________ Installation 2-35