Novell Netware Configuration; Configure The Novell Server - Xante ScreenWriter 3 Manual

5. Choose File: Quit. Command Center closes.
6. Restart the Printer to make the new zone name effective.

Novell NetWare Configuration

Your printer's Ethernet upgrade supports EtherTalk, Novell NetWare
print server, NetBEUI, and TCP/IP protocols concurrently.
In a Novell network, users send print jobs to a queue on a server. The
print server monitors these queues and submits the jobs to the
appropriate network printer. Your printer can service multiple print
queues on up to four file servers.
The following steps are required to set up your XANTÉ printer on a
Novell network. Chapter 2 covers step 1, this section covers steps 2
through 4, and chapter 3 (Macintosh) or 4 (PC) covers step 5.
1. Connect your XANTÉ printer to the network through the
Ethernet port.
2. Configure the Novell server, assigning the print server (your
printer) access to specific queues.
3. Configure the print server emulation to direct your printer to
poll the appropriate Novell server(s).
4. Configure the Novell print server interface on your printer.
5. Install and configure the Adobe PostScript driver on the
individual workstations.

Configure the Novell Server

Using a Novell utility, your Novell System Administrator sets up and
names print servers and print queues on the Novell server. This
section covers selecting Novell names and then configuring for
Novell NetWare Version 3.X, 4.X, or 5.X.
_______________________________________ Ethernet Setup 5-5