Rfid Setup - Printronix SL4M Reference Manual

Chapter 2
RFID ZGL Commands

RFID Setup

Purpose
Format
76
This command sets up parameters including tag type,
read/write position of the transponder, and error
handling.
^RS a , b , c , d , e , f , g , h
^RS RFID Setup command.
a
Selects the tag type. The acceptable
values range is 0 to 5. (This option is
currently not supported.)
b Sets the read/write position of the
transponder in the vertical (Y axis) in dot
rows from the top of the label. Set to 0 if
the transponder is already in the effective
area without moving the media. The
default value is label length minus 1 mm.
The acceptable value range is 0 to label
length.
c Sets the length of the void printout in dot
rows. The acceptable value range is 0 to
label length. (This option is currently not
supported.)
d Sets the number of retries that will be
attempted in case of read/write failure. The
number will reflect in the Label Retry
menu.
e
Error handling. Enter N for no action. Enter
P to place the printer in Pause mode. Enter
E to place the printer in Error mode. (This
option is currently not supported.)
f
Signals on applicator. Enter S to single
signal. Enter D for double signal. (This
option is currently not supported.)
g Certify tag with a pre-read. (This option is
currently not supported.)
h Sets the print speed at which "VOID" will
be printed across the label. (This option is
currently not supported.)