Rfid Write(Ip0), Rfid Read(Ip1); Ptx Setup Commands - Printronix T6000 Reference Manual

Example
<ESC>RK1,0,0,D16,ABCDEF1234567543

RFID Write(IP0), RFID Read(IP1)

Refer to your SATO programmer's reference manual for a description of the RFID command syntax for IP0
and IP1.

PTX SETUP Commands

The PTX SETUP commands are a superset of commands which allow the printer to perform several tasks
by parsing commands either stored in flash or sent to the printer by the host. Commands range from
re-routing debug statements to downloading complete printer configurations. See the Administrator's Manual
for a full description of all the commands available. Those specific to RFID are shown in Table 6.
Concepts to Note
1. PTX_SETUP commands are not emulation specific. They work regardless of how Applications >
Control > Active IGP Emul is setup.
2. The PTX_SETUP command set is case sensitive; all PTX_SETUP commands are in uppercase
characters only.
3. The white space separating commands may be any number of spaces and tabs. This allows a
PTX_SETUP file to be formatted for easier readability.
4. Any unknown command will terminate the PTX_SETUP processing. The offending command will be
the first line of printed text.
Each emulation has modes in which the PTX_SETUP commands could get missed. It is highly
recommended that all PTX_SETUP commands be placed between print jobs, rather than attempting to
embed them within jobs.
PTX_SETUP commands have the following format:
(SFCC)PTX_SETUP
Command-Sub Command; Value
PTX_END
For example, if the SFCC assigned to PTX_SETUP is the default value of the exclamation mark (!, hex 21),
and you want to change the EPC Length for a Higgs-3 RFID tag to 256, use the following command
sequence:
!PTX_SETUP RFID;EPC_LENGTH;256 PTX_END
50
only.