Table of Contents
Advertisement
Chapter
3
Setting SLPA Configuration Parameters
1. Press the Menu key until the following message displays:
MENU MODE
CONFIG. CONTROL
2. Press the ↓ key until the following message displays:
Save Config.
1*
3. Press the + or – key to cycle through the options (1-8). Note that "Factory"
is not listed, because no changes made to the factory configuration can
be saved under Factory.
4. When the desired number displays, press the
following message displays briefly:
Saving
Configuration
When processing is completed, the display shows:
Save Config.
X *
NOTE: If the configuration number has been previously saved and Protect
CONFIG. EXISTS
Delete First
5. Print your configuration and store it in a safe place for future reference.
Refer to "Printing A Configuration" on page 77.
Auto Save Configuration
If you make any changes to the factory default configuration menu items, you
will be prompted to save the changes to "Config #" when you place the SLPA
online. "#" equals the next available unassigned configuration number. When
prompted, press one of the following keys:
•
Enter. Saves to Config 1 or the next available Config, and becomes the
power-up config.
NOTE: If all eight Configs are assigned, you will be prompted to select which
74
Configs. = Enabled under CONFIG CONTROL, the following error
message displays:
If the above occurs, see "Modifying A Saved Configuration" on
page 75, step 4.
Config to overwrite.
↵
key to select it. The
Advertisement
Table of Contents
Troubleshooting
