Covers, Doors, And Service Clearances; Floor Requirements; Weight; Floor Slope - Oracle StorageTek SL3000 System Assurance Manual

Table 7–4 (Cont.) Access Expansion Module Measurements
Dimension
Width
Depth
Service Area

Weight

1
Minimum transportation clearance. There are alignment tabs on each side of the module, which add 4.5
cm to the 91.5 cm width of the module. Therefore, 96 cm is the minimum transportation width.

Covers, Doors, and Service Clearances

Table 7–5
Dimension
Height
Door thickness
Door latches
Service clearance
Side cover

Floor Requirements

The SL3000 library can be installed on a raised, solid, or carpeted floor with a smooth
surface. There must be adequate airflow and the floor must meet environmental
specifications and weight requirements. If the floor is raised, there should not be
ventilation panels directly below the library. If the floor is solid, route cables from the
ceiling to avoid creating a tripping hazard. If the floor is carpeted, make sure the
carpet is approved for computer-room equipment and provides protection from
electrostatic discharge (ESD).
Weight
Ensure the site floor can support the weight of the library. It must support 454 kg
(1,000 lb) per weight distribution pad, which measure 4 by 8 inches. There are four
distribution pads per module.
If the equipment must be transported on elevators, the elevator cars must be capable
of safely handling the weight. Depending on the library configuration the weight of
the library can vary (see

Floor Slope

TallBots must travel along a level plane throughout the library. Any excessive
out-of-plane conditions could cause binding, premature wear, and damage to the
TallBots. Use the jack pads to adjust the library on a sloped floor.
Measurement
91.4 cm (36.0 in.) when placed between module and side cover
96 cm (37.8 in) transport width (no side covers)
99.1 cm (39 in.) with one side cover
77.5 cm (30.5 in.)
Front: 59.7 cm (23.5 in.)
Frame only: 204.2 kg (450 lb)
Shipping: 260 kg (570 lb)

Covers, Doors, and Service Clearance Measurements

Measurement
190.3 cm (74.9 in.) frame only
Front: 1.9 cm (0.75 in.)
Rear: 4.5 cm (1.75 in.)
2.53 cm (0.9 in.)
Front: 45.7 cm (18 in.) for Base and DEM only, 59.7 cm (23.5 in.) for AEM
Rear: 81 cm (32 in.) for Base and DEM only
Side: 5 cm (2 in.) for cooling, 45.7 cm (18.0 in.) for install
7.4 cm (2.9 in.) width
18.5 kg (41 lb) each
"Physical Dimensions and Weights"
Floor Requirements
1
on page 7-2).
Site Planning 7-5