Micromeritics ASAP 2020 Confirm Operator's Manual page 342

ASAP 2020 Confirm
6503- The 1 mmHg transducer offset exceeds recommended limits: (number)
Cause:
Action:
6504- Unable to write the calibration file (name).
Cause:
Action:
6505- Unable to read the calibration file (name).
Cause:
Action:
6506- Calibration file for (file name) is invalid.
Cause:
Action:
6509- The sample has an invalid status and cannot be used for degassing.
Cause:
Action:
B-48
The Pressure Gauge Calibration operation showed the transducer offset
exceeds the recommended limit.
Repeat the Pressure Gauge Calibration operation, if this message
occurs again contact a Micromeritics service representative.
A Save to File operation failed.
Confirm there is sufficient free space on the media receiving the file
and that the media is not corrupted (run ScanDisk). If the problem per-
sists contact a Micromeritics service representative.
A Load from File operation failed.
Confirm there is sufficient free space on the media receiving the file
and that the media is not corrupted (run ScanDisk). If the problem per-
sists contact a Micromeritics service representative.
A Load From File operation failed due to invalid information in the
file.
Confirm there is sufficient free space on the media receiving the file
and that the media is not corrupted (run ScanDisk). If the problem per-
sists contact a Micromeritics service representative.
A file selected for degassing has a status other then No Analysis or Pre-
pared.
Select a different file.
Appendix B
202-42811-01 - Mar 2011