Micromeritics ASAP 2020 Confirm Operator's Manual page 164

ASAP 2020 Confirm
Plot options
X-axis options
Y-axis options
Variable
Overlay
Autoscale
4-88
You can plot data with a curve, points, or both.
Choose Autoscale to have the x-axis scaled automatically.
The X-axis begins at zero and the system uses the highest
value collected during analysis as the ending point.
If you deselect Autoscale, the adjacent fields are enabled so
that you may enter a beginning and ending value. Data
collected outside these ranges are not included in the plot.
X-axis range fields show pore radius or diameter in
angstroms or nanometers.
Data ranges are displayed in the information bar across the
bottom of the dialog when the cursor is in a numerical data
entry field.
Allows you to choose Y-axis options.
Click on the down-arrow to choose a variable for the Y-axis.
You can use the choices in this drop-down list to overlay
plots. You can choose a different type of plot for the current
sample to overlay with the listed Variable, or you can
choose Samples to overlay the Variable plot with the same
type of plot from other samples.
Choose this option to have the y-axis scaled automatically.
Y-axes begin at zero. The system uses the highest value
collected during analysis as the ending point.
If you deselect Autoscale, the adjacent fields are enabled so
that you may enter a beginning and ending value. Data
collected outside these ranges are not included in the plot.
Y-axis range fields show the quantity of gas adsorbed
Data ranges are displayed in the information bar across the
bottom of the dialog box when the cursor is in a numerical
data entry field.
New
202-42811-01 - Mar 2011