Related Manuals for Micromeritics AutoPore V Series
Summary of Contents for Micromeritics AutoPore V Series
- Page 1 V S ERIES ERCURY NTRUSION OROSIMETER ENETROMETER LOSURE 950-42805-00 May 2014...
- Page 2 Contact Us ONTACT Micromeritics Instrument Corporation 4356 Communications Drive Norcross, GA / USA / 30096-2901 Phone: 1-770-662-3636 Fax: 1-770-662-3696 www.Micromeritics.com --------------- U.S. Inquiries U.S. Sales Phone: 1-770-662-3636 USSales@Micromeritics.com --------------- Quotes, Orders, and Customer Satisfaction Customer Service Phone: 1-770-662-3636 Orders@Micromeritics.com --------------- U.S. Instrument Service Department U.S.
- Page 3 ENETROMETER LOSURE IT CONTENTS Contact Micromeritics immediately if any items are missing from the kit. Refer to the Parts and Accessories section of the AutoPore Operator Manual for ordering information on replacement parts. Penetrometer Closure Kit — 950-42805-00 May 2014...
- Page 4 Tighten the Penetrometer Nut IGHTEN THE ENETROMETER 1. Apply grease to the penetrometer bulb and remove any excess grease. 2. Hold the penetrometer upright (sample bulb opening facing upward) and place a seal on the bulb opening. 3. Turn the seal one half turn to smooth the grease and seat the seal. Take care not to move the seal after seating onto the penetrometer bulb.
- Page 5 Remove the Penetrometer Nut EMOVE THE ENETROMETER If the penetrometer nut cannot be easily opened by hand, it may have become sealed too tightly during analysis. Use the penetrometer wrench to remove it. 1. Place the penetrometer tool over the nut. 2.
Need help?
Do you have a question about the AutoPore V Series and is the answer not in the manual?
Questions and answers