Micromeritics ASAP 2020 Confirm Operator's Manual page 331

Appendix B
4052- Fewer than two points are selected for this report.
Cause:
Action:
4053- At least two data points must be selected for t-Plot calculations.
Cause:
Action:
4054- Fewer than two data points are inside the fitted thickness range.
Cause:
Action A:
Action B:
4055- The BET surface area could not be calculated.
Cause:
Action A:
Action B:
202-42811-01 - Mar 2011
At least two points are required for the BET calculations.
Edit the calculation assignments for the BET report.
At least two points are required for the t-Plot calculations.
Edit the calculation assignments for the t-Plot report.
At least two points must be within the fitted thickness range for the t-
Plot calculations.
Edit the calculation assignments for the t-Plot report.
Edit the fitted thickness range in the t-Plot report editor.
Fewer than two points were assigned to the requested surface area cal-
culation in the collected data table.
Assign more points to the surface area calculation.
Select a different surface area in the t-Plot report editor.
ASAP 2020 Confirm
B-37