Micromeritics ASAP 2020 Confirm Operator's Manual page 329

Appendix B
4043- 1.0 cannot be a starting or ending pressure for a geometric progression toward
saturation.
Cause:
Action:
4044- Points in the Langmuir report pressure table lie outside the collected data.
Cause:
Action:
4045- Points in the report pressure table lie outside the collected data.
Cause:
Action:
4046- (file name) could not be opened for reading.
Cause:
Action:
4047- Warning: An error occurred while reading (file name).
Cause:
Action:
202-42811-01 - Mar 2011
You selected to generate a pressure table from a geometrically pro-
gressing range.
Change the 1.0 entered value.
Calculation assignments are not being used and more than one of the
report pressure table points is above the range of the collected data, and
more than one is below.
Change the report pressure table to be more consistent with the col-
lected data.
Calculation assignments are not being used and more than one of the
report pressure table points is above the range of the collected data, and
more than one is below.
Change the report pressure table to be more consistent with the col-
lected data.
A thickness curve file could not be opened.
If the problem persists, restart your computer and optionally perform a
media integrity check (using ScanDisk).
An error happened during a read operation of a thickness curve file.
If the problem persists, restart your computer and optionally perform a
media integrity check (using ScanDisk).
ASAP 2020 Confirm
B-35