Micromeritics ASAP 2020 Confirm Operator's Manual page 335

Appendix B
4071- The selected pressures points do not form a valid set for deconvolution.
Cause:
Action A:
Action B:
4072- The range of pressures selected is too small to deconvolute using this model.
Cause:
Action:
4073- The analysis gas (name) does not match the model gas (name).
Cause:
Action:
4076- Invalid sample file - Adsorptive Properties "Non-condensing adsorptive" can-
not be used unless Analysis Conditions "Absolute pressure dosing" is selected.
Cause:
Action A:
Action B:
202-42811-01 - Mar 2011
The data points selected for analysis do not contain enough informa-
tion to allow a DFT Plus data reduction.
Edit data points in the table of the Collected Data dialog, or select
another sample file. At least two points with strictly increasing pres-
sures and volumes adsorbed are required for a DFT Plus data reduc-
tion.
Edit the pressure range on the DFT report options dialog.
A null result was found using the selected model.
Edit data points in the table of the Collected Data dialog, or select
another sample file. At least two points with strictly increasing pres-
sures and volumes adsorbed are required for a DFT Plus data reduc-
tion.
The model assumes a specific gas and the sample file uses a different
one.
Select a model that assumes the same gas.
You selected a sample file that has Non-condensing adsorptive
selected in the Adsorptive Properties but does not have Absolute pres-
sure dosing selected in Analysis Conditions.
If you plan to use a non-condensing adsorptive, select Absolute pres-
sure dosing on the Analysis Conditions dialog.
If you are not using a non-condensing adsorptive, deselect the Non-
condensing adsorptive option on the Adsorptive Properties dialog, or
choose an adsorptive that you are sure in not non-condensing.
ASAP 2020 Confirm
B-41