Rip Metricin - H3C S5820X Series Command Reference Manual
Layer 3 - ip routing
Hide thumbs
Also See for S5820X Series:
- Command reference manual (488 pages) ,
- Configuration manual (252 pages) ,
- High availability configuration manual (233 pages)
Table of Contents
Advertisement
By default, an interface is enabled to receive RIP messages.
Examples
# Disable VLAN-interface 10 from receiving RIP messages.
<Sysname> system-view
[Sysname] interface vlan-interface 10
[Sysname-Vlan-interface10] undo rip input
rip metricin
Syntax
rip metricin [ route-policy route-policy-name ] value
undo rip metricin
View
Interface view
Default level
2: System level
Parameters
route-policy route-policy-name: Specifies the name of a routing policy used to add an additional metric
for the routes matching it. The name is a string of 1 to 63 characters.
value: Additional metric added to received routes, in the range of 0 to 16.
Description
Use the rip metricin command to configure the interface to add a metric to the routes it receives.
Use the undo rip metricin command to restore the default.
By default, the additional metric of a received route is 0.
When a valid RIP route is received, the system adds a metric to it and then installs it into the routing table.
The metric of the route received on the configured interface is then increased. If the sum of the additional
metric and the original metric is greater than 16, the metric of the route will be 16.
If a routing policy is referenced with the route-policy keyword, the following operations can be
performed:
Routes matching the policy is added with the metric specified in the apply cost command
•
configured in the policy. Routes not matching it is added with the metric specified in the rip
metricout command. The rip metricout command does not support the + or – keyword—used to
add or reduce a metric—specified in the apply cost command. For more information about the
apply cost command, see the chapter "Routing policy configuration commands."
If the apply cost command is not configured in the policy, all the advertised routes is added with the
•
metric specified in the rip metricout command.
Examples
# Configure VLAN-interface 10 to add a metric of 6 for incoming route 1.0.0.0/8 and to add a metric
of 2 for other incoming routes.
<Sysname> system-view
[Sysname] ip ip-prefix 123 permit 1.0.0.0 8
[Sysname] route-policy abc permit node 0
52
Advertisement
Table of Contents
