Cabletron Systems SmartSwitch 9W006 User Manual page 99

If the AppleTalk address for the router is not same as the one displayed when issuing atalk
port console command, then the Local Mac is getting the information from another router.
Please refer to the document for the router.
If the AppleTalk address for Router is the same as the one displayed after issuing the atalk
port console command, contact your Distributor or Customer Support.
Problem:
Only local zones appear and remote zones are not shown in the Mac's Chooser:
Action:
1. Verify that a static route to the remote network is properly configured on the SmartSwitch
Remote Access Module. The static route is configured using SFVRA-CFG.
2. If the static route is not configured correctly, make the appropriate corrections. To check the
AppleTalk static routing information:
a. If it is not already running, start up SFVRA-CFG.
b. From the toolbar, select Functions, click AppleTalk Network, then Systems, or click
the toolbar.
c. Double click on the system in question.
d. Click on the Static Routes tab.
e. Double click on the static route in question.
f. Verify the information entered for the static route. Make any necessary changes.
g. If you made any changes, download the new configuration files to the site.
P D
ROBLEM IAGNOSIS
AppleTalk Routing
on
9W006 and 9W007 99