Udp Statistics; Wan L1P Statistics; Pri S/T (T1/E1) Interface Statistics - Cabletron Systems SmartSwitch 9W006 User Manual

USER'S GUIDE
ACK Packets Sent
Displays the total number of ACK Packets sent.
ACK Packets Received
Displays the total number of ACK packets received.
TFTP Sessions Opened
Displays the total number of TFTP Sessions that have been opened.
TFTP Sessions Closed
Displays the total number of TFTP Sessions that have been closed.
TFTP Sessions still open
Displays the total number of TFTP Sessions that are still open.
UDP S
TATISTICS
If the IP operating mode is enabled, you can access the following UDP statistics by using the udp
stats command:
udpInDatagrams
The total number of UDP datagrams delivered to UDP devices.
udpInErrors
The number of received UDP datagrams that could not be delivered for reasons other than the lack
of an application at the destination port.
udpNoPorts
The total number of received UDP datagrams for which there was no application at the destination
port.
udpOutDatagrams
The total number of UDP datagrams sent from this system.
WAN L1P S
TATISTICS
You can access WAN L1P statistics by issuing the wan l1p stats display
<slot #> console command. These statistics are divided into the following groups of statistics:
PRI S/T (T1/E1) interface statistics, error statistics, and layer 1 general statistics. These groups are
defined below.
PRI S/T (T1/E1) I
NTERFACE
Layer 1 Up
The number of times layer 1 has reported itself up to the upper ISDN layers.
Layer 1 Down
The number of times layer 1 has reported itself down to the upper ISDN layers.
260 SmartSwitch Remote Access Module
S
TATISTICS