Cabletron Systems SmartSwitch 9W006 User Manual page 59

100.0.0.0
The steps to verify the operation of IP routing over a WAN interface are:
1. Determine if a remote IP host can access the WAN interface of the SmartSwitch Remote Access
Module over the WAN connection. On the remote IP host, type:
ping 192.100.1.1 <return>
If the remote IP host successfully pings to the SmartSwitch Remote Access Module, then
continue with the next step.
If the remote IP host CANNOT ping to the system, refer to
Connection in the Problem Diagnosis chapter.
2. Determine if a remote IP host can access the LAN interface of the SmartSwitch Remote Access
Module over the WAN connection. On the remote IP host type:
ping 100.0.0.1 <return>
If the remote IP host successfully pings to the SmartSwitch Remote Access Module, then
continue with the next step.
If the remote IP host CANNOT ping to the SmartSwitch Remote Access Module, refer to
Routing Over a WAN Interface Connection
3. Determine if a remote IP host can access the local IP host through the system over the WAN
connection. On the remote IP host type:
ping 100.0.0.2 <return>
If the remote IP host successfully pings to the local IP host, then IP routing over WAN type
interface is operational. Repeat the above steps for each WAN type interface through which
you wish to get access.
MMAC-Plus with
MMAC PLUS
SmartSWITCH
C a b l e t r o n
Systems
Remote Access Module
192.100.1.1
100.0.0.1
Host A
100.0.0.2
in the Problem Diagnosis chapter.
S
YSTEM
Verifying IP Routing Over Interfaces
ISDN
Host B
192.100.1.3
IP Routing Over a WAN Interface
9W006 and 9W007
V
ERIFICATION
IP
59