Cabletron Systems SmartSwitch 9W006 User Manual page 143

S M
YSTEM ESSAGES
System Message Summary
LAN Adapter software version conflict
When software is downloaded onto the Ethernet adapter, its software version is compared to the
version of software running on the host's main processor. If the versions do not match, this message
is posted. The upgrade did not work properly; contact your Distributor or Customer Support.
LAN Adapter System resource error
LAN Adapter hardware failure detected. If the problem persists, replace your LAN adapter.
LAN Init Error
LAN connection failure. Initialization failure detected by the LAN packet forwarding component
in the system.
LAN Port <port # > detected a transceiver problem
The system detected a LAN connection problem on the indicated port. Check for proper LAN
connection installation.
LAN Port <port # > detected jabber condition <n> times(s)
A "jabber" condition or an Ethernet frame larger than the maximum legal length has been received.
This message is usually displayed if there is a malfunctioning transceiver or a malfunctioning
Ethernet device on the LAN. This message is not displayed for every error condition. It appears
after 24 hours since the last message was displayed. This message provides the LAN port # in
question, and the number of times <n> the jabber condition has been detected.
LAN Port <port # > detected open LAN media
The system detected a problem with the physical LAN on the indicated port. The LAN is not
properly terminated or the LAN is not fully connected to the system. Check for proper LAN
installation.
LAN Port <port # > detected shorted LAN media
The system detected a problem with the physical LAN on the indicated port. The LAN is not
properly terminated or the LAN is not fully connected to the system. Check for proper LAN
installation.
LAN Port <port # > is now in the Forwarding state
The bridge LAN port indicated has entered the forwarding state and is now ready for data transfer.
LAN Port <port # > is now in the Learning state
The bridge LAN port indicated has entered the specified state.
LAN Port is now in the Listening state
The bridge LAN port is entering the specified state.
LAN Port <port # > is now in the <new state> state
The bridge LAN port indicated is entering the specified new state.
LAN Xmit Error
LAN connection failure. LAN packet transmit error detected by the system.
Layer 1 sync not seen - Slot=<slot # > Port=<port# > Ces=<communication endpoint suffix
A physical problem has been detected on the indicated line. Check for proper connection to the
SmartSwitch Remote Access Module and to the NT1 or CIU. If the NT1 or CIU appears functioning
properly, call your phone company and report the problem.
9W006 and 9W007 143