Cabletron Systems SmartSwitch 9W006 User Manual page 207

network range
For a LAN port, this specifies the AppleTalk network range of the LAN segment to which the
port is connected. For a WAN port, this specifies the AppleTalk network range of the logical
segment to which the port is connected. For NonExtended networks, the range will appear as
one number (for example, 121-121). For UnNumbered ports, the range will appear as either 0-
0 (nonextended networks) or 0.0-0.0 (Extended networks). Note that if the network is
nonextended (phase 1), this field will be network (and will display a singular value) as opposed
to network range (which displays a range).
flags
This will reflect any flags that have been activated for the indicated port. Possible flags are:
extended - This flag is triggered if a network range has been configured for the port.
phase-1 - This flag is triggered if the NonExtended network type is configured for the port.
phase-2 - This flag is triggered if the phase-1 flag has not been triggered.
probe-invalid - This flag is triggered if the port sends out a probe to see if its suggested
AppleTalk address is unique on the network, and a response comes back indicating that
the address is already in use, and cannot be used by this port.
soft-seed - This flag is triggered if the port is not configured in the discovery mode (it is
configured with a suggested network range). Its classification as a soft-seed router indicates
that it does have a suggested network range, but that range can be overridden if necessary.
default zone
The port's configured default zone.
LAN port
For LAN ports only. Indicates the Ethernet resource's port number associated with this
AppleTalk LAN port.
physical address
For LAN ports only. The device's MAC address.
remote device
For WAN UnNumbered ports only. The remote device configured to use this port.
atalk port stats [clear]
This command will display or clear current AppleTalk port statistics. Refer to
Statistics, for a list of available atalk port statistics and their definitions.
atalk route
This command will display AppleTalk static route information. A sample output screen is
shown below:
network range distance
------------- --------
225 - 226 0
The fields in this display are defined as follows:
network range
The remote AppleTalk network range reachable through this static route. Note that if there is
only a single network number instead of a range, that number will appear twice under the
network range field.
state next hop
------ --------
good 0.0
S
YSTEM
AppleTalk Routing Commands
AppleTalk Port
zones valid
-----------
TRUE
9W006 and 9W007
C
OMMANDS
207