Call Control Commands - Cabletron Systems SmartSwitch 9W006 User Manual

<device name> could not be found in the Device Table
Indicates that the device name could not be found in the table of configured device names.
<device name> is already connected
Indicates that a connection to a device can not be initiated if there is already a connection
to that device. The call device command cannot be used to increase bandwidth for an
existing connection.
Call attempt failed
Indicates that the request could not be executed.
More than one match for <device name> found in the Device Table
Displayed if you enter just part of a device name and that part could specify more than one
device name. You will be prompted to enter the device name again, in a more specific
manner. For example, if call device Sch is entered, and there is a device configured
with the name Schultz, and a device configured with the name Schmidt, this message
would be displayed. You would then need to enter at least call device Schu to
successfully initiate a call to the device Schultz.
<device name> is not callable
Each PPP device in the device database can have one or two phone numbers at which they
can be called. This message is displayed if the device has no phone number specified.
Re-enter the name, or <RET> to cancel
The device name must be re-entered.
Unable to prompt for device name at this time
Indicates that the call command would prompt you for a device name, but the necessary
resources are not available. The recommended actions are as follows:
1. If possible, enter the device name on the command line.
2. If the device name cannot be entered from the command line (for example, the device
name contains command line delimiters of a space, a comma, a colon, or a tab), the user
can wait for a few minutes and see if any resources become available.
3. If actions 1 and 2 are ineffective, this may indicate an internal problem in the System,
please inform your service representative of the occurrence.
call peer <phone number> [data rate] [device] [bearer]
Initiates a call to a peer at the given number. Entering the data rate, device, and bearer is
optional. We describe each of the optional fields below.
data rate
The default data rate value for HDLC calls is 56Kbps. The default data rate for digital modem
calls is Auto.
device
The valid values are:
• HDLC: used for normal HDLC-ISDN calls
• DM: used for Digital Modem calls.
S C
YSTEM OMMANDS

Call Control Commands

9W006 and 9W007 211