Dedicated Connections; Remote Device Connectivity - Cabletron Systems SmartSwitch 9W006 User Manual

USER'S GUIDE
c. From the displayed list, double click on a circuit (line).
d. Click on the Data Link tab.
e. Check the data link information. Make corrections as required.
f. If you made any changes to the configuration, download the new configuration files to
effected site.
For more detailed instructions, refer to the following sections in the SFVRA Configuration
Manager User's Guide:
• For data links: refer to Configuring Circuit Data Links in the Configuring Circuits chapter.
• For downloading configuration files: refer to Downloading Configuration Updates in the
Exporting Configuration Files chapter.
D C
EDICATED ONNECTIONS
Problem:
A dedicated connection is not functioning.
Action:
If the dedicated connection is not up, this usually indicates that the device could not be validated
for some reason. Check the configuration for the device that will be using the dedicated connection,
and make any necessary corrections.
R D C
EMOTE EVICE
Problem:
A remote device is not able to connect to the SmartSwitch Remote Access Module.
Set-up:
The system software should be up and running. (At the administration console: if you are in the
Connection Monitor window, exit to the "[System Name] >" prompt.)
1. Enable the call trace messages with the trace on console command.
2. Erase the current system messages using the er console command.
3. In a controlled manner, initiate an ISDN connection from the remote device.
Action:
1. After a connection has been initiated, view the system messages (display system messages by
issuing the dr console command). Look for the following call request messages among the
system messages:
In - INCOMING CALL Call Id=<call Id> Slot =<slot #> Port=<port #> Chans=<bearer
channel map> Ces=<comm endpoint suffix> Rate=<data rate>
80 SmartSwitch Remote Access Module
ONNECTIVITY