Cabletron Systems SmartSwitch 9W006 User Manual page 112

USER'S GUIDE
Adapter # 'x' failed to respond from bootstrap
The WAN card initialization subsystem encountered an error on the indicated adapter while
downloading the bootstrap program. Restart the system. If the problem persists, the indicated
adapter card may be faulty and you should contact your Distributor or Customer Support.
Adapter failed to respond while programming: adapter 'x'
The WAN card initialization subsystem encountered an error on the indicated adapter while
programming the hardware. Restart the system. If the problem persists, the indicated adapter card
may be faulty and you should contact your Distributor or Customer Support.
Administrative Session using ACE does not support password change.
Passwords may only be changed via the ACE Server administrator initiation. During an
administrative login, the user attempted to change password. ACE only supports password change
initiated by ACE Server administrator.
AppleTalk routing initialized successfully.
This message is posted when the system AppleTalk routing feature has initialized successfully.
AppleTalk routing RTMP initialization error, AppleTalk disabled
AppleTalk is disabled because there is an initialization problem with the Routing Table
Maintenance Protocol (RTMP). Contact your distributor or Customer Support.
AppleTalk routing ZIP initialization error, AppleTalk disabled
AppleTalk is disabled because there is an initialization problem with the Zone Information
Protocol (ZIP). Contact your distributor or Customer Support.
AppleTalk successfully initialized on LAN port <port number> with address <AppleTalk address>.
This message is posted when the specified AppleTalk LAN port has initialized successfully.
AppleTalk successfully initialized on WAN port with address <AppleTalk address>.
This message is posted when the specified AppleTalk WAN port has initialized successfully.
Attempting to Autobaud, Press <CR> Many Times, Quickly
The user has requested that the RS 232 port undergo an autobaud procedure, or the RS232 port has
not been properly Autobauded.
Attempting to load "<FileName>" for Upgrade
A Reliable Remote Upgrade has taken place. The specified file is now being loaded into memory
for verification and subsequent installation into the Flash File System.
Attempt to reinitialize DM card in slot <slot # >
The system is attempting to initialize the Digital Modem card again after a failed attempt. Check
the subsequent log messages for the status of the card.
Attempt to initialize unconfigured DM card in slot <slot # >
The system is attempting to initialize a Digital Modem card, with no success. This is likely a
configuration problem. Check SFVRA-CFG setup to ensure that it correctly matches existing
hardware.
112 SmartSwitch Remote Access Module