Verify Ip Rip Input Processing Operational On Awan Interface; Verifying Ipx Router Is Initialized - Cabletron Systems SmartSwitch 9W006 User Manual

USER'S GUIDE
V IP RIP I
ERIFY NPUT
To verify that IP RIP Input Processing (routes learning) is properly operational on a WAN interface,
the IP RIP processing must be successfully initialized.
The same example that is used in the previous section is used to verify IP RIP input processing on
a WAN interface.
To verify the operation of IP RIP Input processing on a WAN interface:
1. Make sure that a dedicated connection between system and Router is up and operational. On
the SmartSwitch Remote Access Module administration console:
Type: cs <return>
If the connection to Router is displayed, the continue with the next step.
2. Determine if system has learned the route to 192.1.2.0 from the Router. On the SmartSwitch
Remote Access Module administration console:
Type: ip route <return>
If the route to 192.1.2.0 is displayed, the IP RIP input processing is operational.
If the route is NOT displayed, refer to
Diagnosis chapter.
V IPX R
ERIFYING OUTER IS
To verify that the IPX Routing option has initialized properly.
1. Determine if IPX routing has been initialized on the SmartSwitch Remote Access Module by
viewing the system messages. To display the messages enter the following console command:
dr <return>
2. Look for the following IPX message among the system messages:
[IPX] IPX router is initialized successfully
Also, for each IPX interface that has been configured, the following interface initialization
message should be displayed among the system messages.
[IPX] Network initialized successfully on xxxxxxxx:xxxxxxxxxxxx
Note: Other messages may also be displayed with the IPX router initialization messages.
If you see these IPX router initialization messages, the IPX router is initialized.
If these IPX router initialization messages are NOT displayed, refer to
in the Problem Diagnosis chapter.
66 SmartSwitch Remote Access Module
P O
ROCESSING PERATIONAL ON A
I
NITIALIZED
WAN I
NTERFACE
IP RIP Input Processing on a WAN Interface in the Problem
IPX Routing Initialization