Cabletron Systems SmartSwitch 9W006 User Manual page 271

Command
modem upgrade <slot#
modem# >
modem devices <data>
neif
pkt capture <connection mode>
pkt mac
pkt [on/off]
pkt display
pkt load <filename>
pkt save <filename>
pswd (GUEST)
quit
restore
restart
session
session kill <session id>
snmp stats
sp
start_ne
status (GUEST)
tcp conns
tcp stats
telnet
telnet <ip-address>[port # ]
Use
installs new modem firmware onto specified modem
displays active modem connections
displays the interface table
specifies which packets will be captured by the packet
capture feature (all, reqd, pend, actv, idle, or none)
enables the MAC address monitor display
enables or disables the Packet Capture feature
displays captured packets
loads previously saved Packet Capture file into memory
saves captured packets to a disk file
changes password for current access level
terminates system program
copies backup config files into current files
restarts the system program remotely using Telnet
displays the current active administration sessions
terminates the active session specified by the session id
displays current SNMP related statistics
lists each semi-permanent device and associated status
starts or restarts system software
displays system errors and system messages
displays the current TCP connection status
displays the current system TCP statistics
puts you in the Telnet command mode
see telnet mode commands for available commands
begins a Telnet session for the indicated Telnet host
A C
DMINISTRATIVE ONSOLE
9W006 and 9W007
C T
OMMANDS ABLE
271