Cabletron Systems SmartSwitch 9W006 User Manual page 164

USER'S GUIDE
Unable to send DL Config Request
Unable to send DSL Config Request
Unable to send Terminate DSL Request
The above three messages indicate that an attempt has been made to dynamically update the Data
Link configuration, but the system is unable to send an update message down to a Basic Rate
adapter. Restart the system and review the configuration for the adapter. If the problem persists,
the indicated adapter card may be faulty. Contact your Distributor or Customer Support.
Unexpected error during transmission of LMI frame
A system error occurred during the actual transmit request for an LMI frame. Contact your
Distributor or Customer Support.
Unknown Calling Bridge <MAC address>
MAC address security is enabled and the remote Combinet does not match any of the defined
devices.
Unknown DLCI <dlci index> in CLLM message
The network has sent a CLLM message which has referenced the indicated DLCI that has not been
configured. Check the system configuration for the indicated DLCI.
Unknown Security Association
An incoming datagram specifies a Security Parameter Index (SPI) which has not been defined on
this node. Verify the encryption parameters on both nodes. Adjust if necessary so that both nodes
reflect the same SPI.
Unmatched Login Task
This represents an internal system error. Contact your Distributor or Customer Support.
Unsupported Combinet protocol received: <protocol Id>
An unsupported Combinet protocol attempted to connect to the system. Contact your Distributor.
You may need to upgrade software to support this.
Unsupported Combinet protocol version received: '<version Id>'. [Device: <device name>]
An unsupported Combinet version attempted to connect to the system. Contact your Distributor.
You may need to upgrade software to support this.
Updating SmartSwitch Remote Access Module from "<FileName>"
The specified file, received during a Reliable Remote Upgrade, was successfully loaded into
memory and will now be verified before installation into the Flash File System.
User Level Authentication flag is enabled for Terminal User xxx. Setting flag to disabled.
The device definition for xxx should have User Level Authentication disabled.
These two messages are displayed together. In device entries for terminal server connections, user-
level authentication should not be enabled. In the event the SmartSwitch Remote Access Module
finds an enabled condition, it will disable the pertinent flag for the duration of the call only. To
avoid this situation permanently, disable the user level authentication flag in device entries for all
terminal server connections.
Waiting for WAN card in slot <slot # > to complete initialization
Download process update for WAN card in slot <slot # >.
164 SmartSwitch Remote Access Module