Trace Commands - Cabletron Systems SmartSwitch 9W006 User Manual

session information for a TFTP session that has terminated. The screen below illustrates the use
of this command.
> TFTP SESSION
Id Sess-Id Local file
----------------------------------------------------------
1 5 temp.txt
2 6 tmp
3 7 text.txt
Select the ID of the TFTP Session to display or <RET> to cancel? 2
TFTP Session ID:
Type:
Mode:
Local Address:
Local File:
Remote Address:
Remote File:
Transfer Mode:
Bytes Transferred:
Bytes Remaining:
Total Retries:
tftp stats
Displays the current TFTP related statistics. Refer to
statistics and their definitions.
T C
RACE OMMANDS
Note: For an explanation regarding the output resulting from the family of trace commands, refer
to the Trace Messages
The following commands are used to enable and disable trace reporting information:
trace ipxwan [on/off]
Enables or disables the IPXWAN tracing option, which tracks all packets which are received or
sent out using IPXWAN protocol, and places this information in the system log. To display the
log file, issue the dr command. This option is initially disabled.
trace [on/off]
Enable or disables the call trace information reports. If enabled, you can then view the logged
call trace information by issuing the dr command. For details on call trace messages, refer to
the chapter titled
trace ppp [on/off]
Enables or disables the tracing of incoming and outgoing PPP packets. If enabled, you can view
the trace PPP information by issuing the dr command.
Type/Mode Bytes Xmit Retries
Client/Put
Server/Get
Server/Put
6
Server
Get
190.5.6.8 (UDP Port: 5001)
c:\tmp
190.5.6.11 (UDP Port: 5011)
N/A
netascii
935
1145723
0
chapter.
Trace Messages.
12752 1
423 0
8481 0
TFTP Statistics, for a list of available
S C
YSTEM OMMANDS

Trace Commands

9W006 and 9W007 233