Initialization Messages; Normal Operation Messages; Spanning Tree Messages; Warning Messages - Cabletron Systems SmartSwitch 9W006 User Manual

USER'S GUIDE
I M
NITIALIZATION ESSAGES
The system reports a variety of messages during a successful system initialization. These messages
may include: status of bridge, status of LAN ports and adapters, data link, SNMP, and TFTP
information. The following are examples of typical initialization messages:
Bridge is operating in UNRESTRICTED mode
Data link up: Slot=<slot #> Port=<port #> Ces=<comm. endpoint suffix>
[SNMP] SNMP initialized successfully
N O
ORMAL PERATION
The system normal operation messages may include information such as:
Call Restrictions have been disabled by user command
WAN Port is now in the <new state> state
S T M
PANNING REE ESSAGES
The Spanning Tree protocol is only supported by the Ethernet-2 interface card.
Spanning Tree protocol messages are prefaced with [STP]. During normal operation, when
Spanning Tree protocol is enabled, the system may report informational messages such as:
[STP] A new Root Bridge has been detected
[STP] LAN Port <port #> is now a Designated Port
W M
ARNING ESSAGES
System warning messages signal events that you should investigate. These messages may be
normal during certain network conditions, or they may indicate a problem. The system should
continue to operate after posting a warning message. If the system fails to operate normally, then
report it using the problem report form included in
E M
RROR ESSAGES
When the system detects errors, it reports error messages. If the faulty component cannot be
identified, and an error condition persists, then report the error by using the problem report form
included in Getting
S M
YSTEM ESSAGE
The following pages list all the informational, warning and error messages alphabetically. The text
describes the messages, and includes suggestions for problem resolution (if applicable). Note that
the trace messages have been isolated for your convenience, and are summarized in the next
chapter.
<timestamp> # 000: Couldn't open the file C:\SYSTEM\PLATFORM.NEI
The open operation failed, no further detail is available.
<timestamp> # 0000: Error reading C:\SYSTEM\PLATFORM.NEI
The read operation failed, perform a software upgrade to reinstall the file.
110 SmartSwitch Remote Access Module
M
ESSAGES
Assistance.
S
UMMARY
Getting Assistance.