Verifying Wan Lines Are Available For Use - Cabletron Systems SmartSwitch 9W006 User Manual

USER'S GUIDE
3. Determine if the LAN adapter resource is operational by viewing the system messages. At the
administration console type:
dr <return>
The dr command displays the current system messages. Look for these LAN adapter
initialization messages among the system messages:
LAN Adapter Reset
LAN Adapter ROM version #.#.#
Note: Other messages may also be displayed with the LAN adapter initialization messages.
If these LAN adapter initialization messages are NOT displayed, refer to
Problem Diagnosis chapter.
4. If you have enabled bridging, look for these LAN adapter initialization messages among the
system messages:
LAN Port <port #> is now in the LISTENING state
LAN Port <port #> is now in the LEARNING state
LAN Port <port #> is now in the FORWARDING state
5. If you have enabled IP routing, look for this LAN adapter initialization message among the
system messages:
[IP] IP router is initialized successfully
Note: Other messages may also be displayed with the LAN adapter initialization messages.
If these LAN adapter initialization messages are displayed, then the LAN adapter is operational.
Proceed to the next section.
If these LAN adapter initialization messages are NOT displayed, refer to
Problem Diagnosis chapter.
V WAN L
ERIFYING
To verify the availability of WAN lines, the WAN resource must already be operational. Also, the
WAN lines must already be configured and connected to the SmartSwitch Remote Access Module.
To verify the availability of WAN lines:
1. Determine if WAN lines are operational by viewing the system messages. At the
administration console type:
dr <return>
The dr command displays the current system messages.
2. For each primary rate line configured and attached to the SmartSwitch Remote Access Module,
the following line initialization message should be displayed among the system messages:
Data Link up: <slot #> <port #> <ces>
54 SmartSwitch Remote Access Module
A
INES ARE VAILABLE FOR
LAN Adapter
U
SE
LAN Adapter in the
in the