Cabletron Systems SmartSwitch 9W006 User Manual page 126

USER'S GUIDE
DM card in slot <slot # > failed FLASH download
The system has failed to successfully update the firmware revision of the Digital Modem card.
Contact your Distributor or Customer Support.
DM card in slot <slot # > FLASH download complete
Informational message stating that the system has successfully updated the firmware present on
the Digital Modem card.
DM card in slot <slot # > signals it is operational
Informational message stating that the Digital Modem is now ready for use.
DM card type configured in slot <slot # > does not exist
Using the resource database, the system has tried to initialize a Digital Modem card that doesn't
exist. Check all switch and/or jumper settings on the board to ensure they match the values in
SFVRA-CFG. If the board is configured properly, and the message still appears, contact your
Distributor or Customer Support.
DM card in slot <slot # > will not come out of reset
There are problems initializing the board. Contact your Distributor or Customer Support.
DM upgrade timeout. Board=<board # >, Modem=<modem # >
DM upgrade error during download. Modem says = xxx
DM upgrade no response at start. Board=<board # >, Modem=<modem # >
DM upgrade flash erase failed. Board=<board # >, Modem=<modem # >
DM upgrade no response at end. Board=<board # >, Modem=<modem # >
There were problems while attempting to update the firmware of the specified modem due to
either a corrupt firmware file or hardware problems. Reseat the card in its ISA slot, and/or check
the MVIP cabling. If problems persist, contact your Distributor or Customer Support.
DM upgrade started. Board=<board # >, Modem=<modem # >
The system has begun to update the firmware of the specified modem on the Digital Modem card.
Watch for subsequent log messages to ensure the update is successful.
DM session in unknown upgrade state. Board=<board # >, Modem=<modem # >
There were problems while attempting to update the firmware of the specified modem due to
either a corrupt firmware file or hardware problems. Contact your Distributor or Customer
Support.
DM upgrade success. Board=<board # >, Modem=<modem # >
The system has successfully updated the firmware of the specified modem on the Digital Modem
card.
DM: TimeSlot driver circuit id already in use on CREATE
DM: No TimeSlot driver circuits available for CREATE
DM: TimeSlot driver circuit id not in use on REMOVE
DM: TimeSlot driver circuit id not found on REMOVE
There were problems related to the Digital Modem's use of the TDM bus. Contact your Distributor
or Customer Support.
Downloading Bootstrap to DM card in slot <slot # >
Informational message stating that the system is attempting to initialize a Digital Modem card.
Watch for subsequent log messages to ensure the initialization is successful.
126 SmartSwitch Remote Access Module