Hardware Installation; Overview; Installing The Smartswitch Remote Access Module; Unpacking The Smartswitch Remote Access Module - Cabletron Systems SmartSwitch 9W006 User Manual

H I
ARDWARE NSTALLATION
O
VERVIEW
This chapter provides a brief description of the SmartSwitch Remote Access Module hardware
installation process including instructions for:
• installing the 9W006/9W007 module in to a SmartSwitch 9000
• connecting the module's cabling
In case you need to restart the module during installation, instructions are also included for
restarting the
I S
NSTALLING THE
This section contains
guides you through
for resetting the module.
Only qualified personnel should install the SmartSwitch
!
Remote Access Module.
CAUTION
The SmartSwitch Remote Access Module and the host
SmartSwitch 9000 are sensitive to static discharges. Use a
grounding strap and observe all static precautions during this
procedure. Failure to do so could result in damage to the
SmartSwitch 9000 or the module.
U S
NPACKING THE MART
Unpack the SmartSwitch Remote Access Module as follows:
1. Remove the shipping box material covering the SmartSwitch Remote Access Module.
2. Carefully remove the module from the shipping box. Leave the module in its non-conductive
bag until you are ready to install.
3. Attach the disposable grounding strap to your wrist and to a proper ground (refer to the
instructions outlined on the grounding strap package).
4. After removing the module from its non-conductive bag, visually inspect the device. If you
notice any signs of damage, DO NOT install the module. Contact Cabletron Systems Technical
Support immediately.
module.
S R
MART WITCH
instructions for unpacking
installing the module into an SmartSwitch 9000.
S R
WITCH EMOTE
A M
EMOTE CCESS
the SmartSwitch Remote Access Module, then
A M
CCESS ODULE
ODULE
Instructions are also provided