Cabletron Systems SmartSwitch 9W006 User Manual page 118

USER'S GUIDE
Calling Line ID Security Failure <calling line Id>, Device: <device name>
The system has rejected a device due to a mismatch between the Calling Line Id presented by the
caller and the Calling Line Id in the on-node device database or obtained via an off-node
authentication server such as RADIUS. The device's name is also contained within the database.
Calling Line ID Security Failure - off-node authentication server not supported
The system authentication type is configured to obtain device information off-node, for example
from a RADIUS server; however, such transactions are not yet supported when Calling Line Id
Security is enabled.
Call_ID in use in HOST_CALL_REQUEST
The system software sent a message to the RBS state machine that the state machine was unable to
recognize or the information was incorrect. If this message is displayed in the log messages, contact
your Distributor or Customer Support.
Call Rejected, Maximum Bandwidth already in place to Device Id <device Id>
An incoming call was rejected because the Maximum Data Rate parameter was exceeded for the
indicated device. The Maximum Data Rate parameter can be configured for PPP devices in SFVRA-
CFG.
Call Rejected, No Called TN IE
The switch did not deliver an Information Element for the call. This problem normally occurs if you
are connected to a point-to-point line and have the System configured for a multipoint line. If you
are connected to a multipoint line and get this message, call your phone company and report the
problem.
Call Restriction statistics reset for new day
Call Restriction device information.
Call Restriction statistics reset for new month
Call Restriction device information.
Call Restrictions will allow calls to be made this hour
Call Restriction device information.
Call Restrictions will allow calls, but this hour is restricted
Calls are restricted during this hour but the action configured is to "Warn". Calls are still being
allowed.
Call Restrictions will allow calls to be made
A Call Restriction limit has been exceeded but calls will still be allowed.
Call Restrictions will no longer allow calls to be made
A Call Restriction limit has been exceeded and calls will no longer be allowed. Existing calls will
NOT be forced down.
Call Restrictions will not allow calls to be made this hour
Call Restriction device information.
Call Summary for <day/month/year> - Calls/Day=x Calls/Mth=x Mins/Day=x Mins/Mth=x
Call Restriction device information. Displays daily/monthly call totals at the end of a day or a
month.
118 SmartSwitch Remote Access Module