Verifying Ip Rip; Verifying Ip Rip Is Initialized; Verifying Ip Rip Output Processing On Alan Interface - Cabletron Systems SmartSwitch 9W006 User Manual

USER'S GUIDE
2. Determine if system B can access system A over the WAN connection. On system B type:
ip ping 100.0.0.1 <return>
If the ping is successful, continue with the next step.
If the system B CANNOT ping to system A, refer to
Interface Connection
V IP RIP
ERIFYING
The following sections provide a method of verifying that IP RIP is initialized, and that it is
processing properly on LAN and WAN interfaces.
V IP RIP
ERIFYING IS
Follow the steps below to verify that IP RIP processing is initialized.
1. Determine if IP RIP processing has been initialized by viewing the system messages. On the
administration console type:
dr <return>
2. The dr command displays the current system messages. Look for the following IP RIP message
among the system message:
[IP RIP] RIP Protocol Initialization successful
If you see this IP RIP initialization message, the IP RIP has initialized successfully.
If this IP RIP initialization message is NOT displayed, refer to
Diagnosis chapter.
V IP RIP O
ERIFYING UTPUT
To verify that IP RIP Output Processing (routes advertisement) is properly operational on a LAN
interface, the IP RIP processing must be successfully initialized. Also, a local IP host (router) must
be connected to the local LAN port on the system and capable of learning routes information via
RIP.
Below is an example of a configuration used to verify IP RIP output processing on a LAN interface.
It uses IP addresses specific to the example. Substitute the IP addresses of your network when you
perform the verification steps. It also uses the netstat administration console command. The
netstat command displays the IP routing table of the system. Substitute the equivalent command
on your IP host.
62 SmartSwitch Remote Access Module
in the Problem Diagnosis chapter.
I
NITIALIZED
P
ROCESSING ON A
IP Routing over a WAN UnNumbered
IP RIP Initialization
LAN I
NTERFACE
in the Problem