Cabletron Systems SmartSwitch 9W006 User Manual page 125

S M
YSTEM ESSAGES
System Message Summary
[DHCP-R] UDP port (67) opened
The DHCP Relay Agent is being enabled and it must open the BOOTPS UDP port (port 67). This
may occur during system initialization. If the DHCP Proxy Client is also enabled, it may not be
necessary for the Relay Agent to open this UDP port.
Dial Out Device does not have Bridge Callable Enabled
Check configuration. Enable the Make Calls for Bridge Data field under Bridging when editing a
connection protocol.
Discrepancy in dynamically-obtained device data
The System authentication type is configured to obtain device information off-node. In an
outbound call scenario with security enabled, two transactions may occur for the same device. If
these do not yield the same information, the call is dropped. Contact your Distributor or Customer
Support.
DL <slot # , port # , ces> Down
The specified data link for a line is down and considered unusable. Refer to the log error messages
for further information ( dr command).
DM card in slot <slot # > has no firmware
While attempting to initialize the Digital Modem card, the system registered an invalid firmware
state. Contact your distributor or Customer Support. You most likely need to replace or upgrade
the firmware on the Digital Modem.
DM card failed FLASH download bad xx SREC
The Digital Modem card has failed the firmware update due to a corrupt file. Contact your
Distributor or Customer Support.
DM card in slot <slot # > has bad FLASH
The FLASH memory on the Digital Modem card has been identified as bad during an attempt to
update or access it. Contact your Distributor or Customer Support.
DM card in slot <slot # > in unknown state
The Digital Modem card is in an unrecognizable state. Reseat the card in its ISA slot, and/or check
the MVIP cabling. If the problem persists, contact your Distributor or Customer Support.
DM card in slot <slot # > is not functional
The system was unable to initialize the Digital Modem in the specified slot correctly. Check all
switch and/or jumper settings on the board to ensure they match the values in SFVRA-CFG. If the
board is configured properly, and this message still appears, contact your Distributor or Customer
Support.
DM card in slot <slot # > will receive new firmware
Informational message stating that the system has detected that the current firmware of the
specified modem is a lower revision level than what is supported in the currently installed
software. For 56K modem technology, the system will attempt to update the card. For modem
technology other than 56K, the upgrade command must be used to upgrade the firmware revision.
Watch for subsequent log messages to ensure the update is successful.
9W006 and 9W007 125