Cabletron Systems SmartSwitch 9W006 User Manual page 145

S M
YSTEM ESSAGES
System Message Summary
Maximum calls per month limit (x) has been reached
The described limit has been exceeded. The next log message will indicate whether calls will still
be allowed or not.
MCP detected channel failure: <channel number>
A link has failed for some abnormal reason and the indicated channel has been disconnected. This
message is generally preceded by another message which indicates the underlying protocol. Refer
to that message. If this does not pinpoint the problem, check the application on the remote device
to see if it is working correctly.
Memory Access Timeout
This indicates a TDM bus connector failure that is specific to the TDM bus connecting a primary
rate and a basic rate adapter. Ensure that the TDM bus has been correctly connected to the two
adapters. If problem continues, contact your Distributor or Customer Support.
MEMORY LIMITED - <x> COMPRESSION connections available
Where "x" is equal to the number of connections that can be supported. There is not enough
memory available to support the number of compression connections being allocated. You may
want to purchase more memory for your system. Contact your Distributor or Customer Support.
Mild congestion CLLM received for DLCI <dlci index>
A CLLM message was received indicating mild congestion may be expected on the PVC associated
with the indicated DLCI.
Mismatch of configured and installed DM card in slot <slot # >
The switch and/or jumper settings on the specified Digital Modem card are not properly set to
match how the card is configured in software. Check the hardware and software configuration and
restart.
Missing BEARER_CAPABILITY in HOST_CALL_REQUEST
Missing CALLED_NUMBER_IE in HOST_CALL_REQUEST
Missing CHANNEL in HOST_CALL_REQUEST
Missing CHANNEL_ID_IE in HOST_CALL_REQUEST
Missing TN in HOST_CALL_REQUEST
The above Robbed Bit Signaling messages indicate that the system software sent a message to the
RBS state machine that the state machine was unable to recognize or the information was incorrect.
If this message is displayed in the log messages, contact your Distributor or Customer Support.
MODEM <modem # > of DM card in slot <slot # > is unusable
An attempt was made to perform an operation on a specific modem that had been deleted from the
usable list via the modem delete command. Use the modem add command to make the modem
usable again, or use a different modem to perform the desired operation.
MODEM CONNECT failed - connect <connect id # >, board <board # >, modem <modem # >
An attempted modem call has failed to connect. Try reconnecting the call again. If this message
consistently appears for the same modem number, contact your distributor or Customer Support.
Modem revision on modem <modem # > of slot <slot # > failed
Individual modems on a Digital Modem card are failing. Check the hardware and software
configurations, as well as the seating of the card and the MVIP cabling. If all seems in order, contact
your Distributor or Customer Support.
9W006 and 9W007 145