Cabletron Systems SmartSwitch 9W006 User Manual page 202

USER'S GUIDE
# 3. Example of three samples where actual bandwidth utilization was around 95% and
underload was not being monitored (probably because only one connection was in place).
In this example, overload is occurring on all three samples.
# 4. Example of three samples where actual bandwidth utilization was around 70% and
underload was being monitored at around 25% utilization of current bandwidth. In this
example, overload is occurring on all three samples.
# 5. Example of three samples where actual bandwidth utilization was around 10% and
underload was being monitored at around 25% utilization of current bandwidth. In this
example, underload is occurring on all three samples.
# 6. Example of three samples where actual bandwidth utilization was around 25% and
underload was being monitored at around 10% utilization of current bandwidth. In this
example, neither overload nor underload is occurring.
From the Throughput Monitor screen, press:
To freeze the current throughput monitor display.
f
To resume the display of throughput monitor samples.
r
<esc> To exit the Throughput Monitor and return to the Connection Monitor screen.
S O
AVING PERATIONAL
The following commands are used to save system operational information to disk:
wr
Writes the current system messages to disk file.
ws
Writes the current system statistics to disk file.
Note: For details on these disk files, refer to the chapter titled
C O
LEARING PERATIONAL
The following commands are used to clear current system operational information:
er
Erases the current system messages held in memory.
es
Erases the current system statistics held in memory.
202 SmartSwitch Remote Access Module
I
NFORMATION
I
NFORMATION
Software Overview.