Call Restriction Commands - Cabletron Systems SmartSwitch 9W006 User Manual

In response to the disc device command, one of the following responses will be displayed:
Disconnecting <device name>
Indicates that the disconnect process has been initiated for the indicated device.
No active connection to <device name>
Indicates that the device that you are attempting to disconnect has no active connection.
The mc or the cs command can be used to view the active connections.
<device name> could not be found in the Device Table
Indicates that the device name could not be found in the table of configured device names.
More than one match for <device name> found in the Device Table
Displayed if you enter just part of a device name and that part could specify more than one
device name. You will be prompted to enter the device name again, in a more specific
manner. For example, if call device Sch is entered, and there is a device configured
with the name Schultz, and a device configured with the name Schmidt, this message
would be displayed. You would then need to enter at least call device Schu to
successfully initiate a call to the device Schultz.
Re-enter the name, or <RET> to cancel
The device name must be re-entered.
Unable to prompt for device name at this time
Indicates that the call command would prompt you for a device name, but the necessary
resources are not available. The recommended actions are as follows:
1. If possible, enter the device name on the command line.
2. If the device name cannot be entered from the command line (for example, the device
name contains command line delimiters of a space, a comma, a colon, or a tab), the
device can wait for a few minutes and see if any resources become available.
3. If actions 1 and 2 are ineffective, this may indicate an internal problem in the System,
please inform your service representative of the occurrence.
C R
ALL ESTRICTION
When the Call Restriction feature is enabled on the SmartSwitch Remote Access Module, the
following command is available through the administration console:
cr stats
Displays the current Call Restriction statistics. Refer to
available statistics and their definitions.
C
OMMANDS
S
YSTEM

Call Restriction Commands

Call Restriction Statistics, for a list of
9W006 and 9W007
C
OMMANDS
213