Bridge Initialization; Ip Routing Initialization - Cabletron Systems SmartSwitch 9W006 User Manual

USER'S GUIDE
B I
RIDGE NITIALIZATION
Problem:
The system does not display the following bridge initialization messages:
LAN Port <port #> is now in the LISTENING state
LAN Port <port #> is now in the LEARNING state
LAN Port <port #> is now in the FORWARDING state
Action:
1. Make sure the
2. Using SFVRA-CFG, check the configuration to verify the bridge is enabled. To do this:
a. If it is not already running, start up SFVRA-CFG.
b. From the toolbar, select Functions then select Sites or click the
c. From the displayed list, double click on the site in question.
d. Click on the Systems tab.
e. Select the system in question, then click on Edit System Settings.
f. Under Bridging information, check to make sure that a check appears next to Enable
(bridging information is included under the Properties tab).
g. If you made a change, download the new configuration files to effected site.
For more detailed instructions, refer to the following sections in the SFVRA Configuration
Manager User's Guide:
• For enabling bridging: refer to Configuring the Site's Systems in the Configuring Sites chapter.
• For downloading configuration files: refer to Downloading Configuration Updates in the
Exporting Configuration Files chapter.
IP R I
OUTING NITIALIZATION
Problem:
The system does not display the expected IP routing initialization messages.
Action:
1. If you did not see the following IP message:
[IP] IP router is initialized successfully
Using SFVRA-CFG, check the configuration to verify that IP routing is enabled. To do this:
a. If it is not already running, start up SFVRA-CFG.
b. From the toolbar, select Functions then select Sites or click the
76 SmartSwitch Remote Access Module
LAN Adapter has initialized correctly.
icon.
icon.